At work I run a Hurco VMX42, I'm not positive but I think the software build is 08.01.09.24.
A few months ago the XMP board that controls XYZ axis went kaput and the following error message was displayed: 'No motion control boards were detected in the system'. The board was replaced, as was the 'backing board' (the board that all of the other drive boards plug in to, basically the motherboard) and the cable that connects the two XMP boards to one-another. The system was also reformatted, because the service technicians that worked the case felt like the software had gone corrupt after another error message was displayed (though I forget what exactly that message was).
A few days after the work was done, during axis calibration, I got an error message reading 'MEI XMP motion controller subsystem failure' and the system shut down. I powered down and restarted, and all was well. I let my manager and boss know, and that's as far as that message went...:rolleyes5:
This morning, after calibrating and warming up the machine, and then completing a program, I was away from the machine for maybe 15 minutes while it sad idle. I came back to the machine to find that the 'MEI XMP motion controller subsystem failure' message had returned. I powered down and restarted, and all was well again. Almost exactly 2 hours later, the same thing happened, the machine was sitting idle and the error occurred. It happened twice more after that, once while manually touching off a tool (jogging Z-) and again while cutting a (very expensive and complex :angry: ) part.
What's going on here? My manager promises we'll call Hurco or Brooks Associates in the morning. I just thought I'd bounce this off the community to see what other ideas are out there for what's going on.
Hurco Winamax Cracked
Hurco winmax mill; hurco winmax mill download; Acronis True Image 8.0.937.full.rar. Hurco winmax mill cool edit pro 2.1 full indir gezginler crack hurco winmax mill download buku yahya waloni pdf 20 41768eb820. In the Hurco Service Window, select Toggle Drive Access Off to enable drive access. The button now reads “Toggle Drive Access On.” 6. In the Hurco Service Window, select Open Explorer to open the File Explorer. Search for the MTConnect install package in the File Explorer and then select Run.